17
16
The learning feature lets your remote “learn” functions
from your original remote control.
1. Press and hold
SETUP
until the indicator remains on,
then release
SETUP
.
2. Repeatedly press and release
SELECT
to select the
desired mode (
TV
,
VCR
, etc.).
3. Press and release
LEARN
; the indicator blinks, then
stays on.
4. Press and release the button that you want to learn
(for instance,
POWER
).
5. Point your original remote at the bottom of your new
remote until they are about 1 inch apart.
6. Press and hold the original remote
button (for
instance, Power) until the indicator blinks once, then
stays on. If there is a learning problem, the indicator
blinks for 3 seconds and stays on. If this happens,
repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want your
remote to learn.
8. Press and release
SETUP
when all desired remote
commands are learned. Code learning is now
complete.
Learning Commands
Line up your remotes (that you’re learning from) in front of
the learning remote on a hard surface approx. 1-inch apart.
4.
2.
1.
3.
6.
This feature assists you in identifying where your
original remote’s infrared (IR) transmitter is located.
This feature is particularly useful if your original
remote’s IR transmitter is hidden behind a lens.
1. Point your remotes so that the top of your existing
remote faces the bottom of your new remote and the
remotes are about 1 inch apart (see picure on next
page).
2. Press and hold
SETUP
until the indicator remains on,
then release
SETUP
.
3. Repeatedly press and release
SELECT
to select the
desired mode (
TV
,
VCR
, etc.).
4. Press and release
LEARN
; the indicator blinks, then
stays on.
5. Press and hold any original remote
button and move
the original remote to the left and right and/or up
and down in front of the IR transmitter.
Note1:
The indicator will remain on if there is not any IR
from the original remote. The indicator will blink on and
off more rapidly when the IR transmitters are lining up.
The point where the indicator blinks most rapidly is
where the two IR transmitters are aligned.
Note2:
Some original remotes only transmit IR on the
initial button press and then stop transmitting IR.
Quickly press and release the original remote button
repeatedly during this procedure in such cases.
IR Transmitter Finder
