X10 IconRemote IR34A, Owner'S Manual

30

31

Next, point the remote you want to learn 
commands from at the bottom of the 
IR34A IconRemote, and press OK when 
you’re ready. (See Tips on Learning on 
page 25.)

  Learning Side Keys, cont.

Next press the key on the other remote 
for the function you want to learn. 
Hold the key pressed until the screen 
says that the command was successfully 
learned. Note for some types of keys you 
might need to hold the key pressed but 
for other types a quick press is suffi cient. 
Experiment a bit. If keys you learn are 
sent multiple times try learning them with 
just a quick press.

You can change the label for the key 
(in this case L7) and/or add the key to a 
Macro. (See page 33 for Macros.)
If you select Change Label, by pressing 
Side Key K9, you can change the name 
to anything you want. For example, 
you’ll likely want to rename it with the 
name of the function that you learned.

After you select Change Label, the screen 
to the right appears. You enter the new 
name for the key using the numeric keys 
on the remote in a similar fashion to 
typing text using a cell phone. See the 
following page.

  Learning Side Keys

At the Home screen press the Side Keys 
next to 

Setup

, 

More

, and then 

Learn

. 

Then press any of the Side Keys K1-K5 
to the left of the screen.

Select the device you want to learn keys 
for. In this example we only have a TV, 
Cable Box and Satellite Receiver set up, 
so the rest are grayed out, but you can 
still select any of the devices to learn 
commands for. In this case we select TV.

Some typical “extra” keys are already set 
up, (depending on the Mode you se-
lected), the rest of them are called L6, L7, 
L8, etc., 27 keys in total. (You can rename 
them later). Press the Side Key that you 
want to learn a command under. (Note: 
You can choose one that already has a 
name, so as to “learn over it” and then 
later rename it.) Let’s select L7.