X10 IconRemote IR34A, Owner'S Manual

46

47

  X10 Home Control

If you own or have purchased the Model IR543 Command 
Center, and you have compatible X10 Lamp, Appliance, and 
Wall Switch modules, you will also be able to control lights 
and appliances from your IR34A IconRemote. You must set up 
the remote with the 0999 device code in order for the IR34A to 
communicate to the IR543 Command Center.

When you point the IR34A toward the IR543, it receives the IR 
commands and retransmits them onto your house wiring. (This 
is now a PLC signal.) Any modules that match the house and 
unit code transmitted will either turn on or off, depending on 
the signal.

To see how to enter a device code, refer to page 43. Set up the 
code under AUX mode, but you can choose another mode if 
you prefer. Then in AUX mode (for example), press a number 
button on the IR34A corresponding to the X10 Module you 
want to control. Press C to turn the module on, 
CHANNEL – turns it off;  to brighten Lamp and 
Wall Switch Modules, and VOLUME – to dim them.

If you own or have purchased the TM751 RF Transceiver 
Module, your IR34A IconRemote communicates using its RF 
signal. The remote transmits the RF signal on a specifi c house 
code. This signal is received by the transceiver (either TM751, 
RR501, CM15A, or security console) on a matching house 
code. (See pages 15 through 20 on how to set up the remote 
and modules.) The transceiver then forwards the signal onto 
the house wiring. This is now a PLC signal. Any modules that 
match the house and unit code transmitted will either turn on or 
off, depending on the signal sent. Camera power supplies are 
addressable and act just like lamp or appliance modules. 

  Advanced Settings, cont.

KidSafe

Press the 

HOME 

key, 

Setup

, 

More

, 

Advanced

, then 

KidSafe

.

The fi rst time you access the KidSafe 
menu you are asked if you want to set up 
a KidSafe Code. If you select Yes, you 
see this screen. Enter a 4 digit code that 
you will easily remember but that your 
Kid(s) won’t be able to guess.

After you enter a 4 digit code and press 
OK, you will see a screen that lets you 
pick a new KidSafe code, i.e., change 
it. And/or set the group of favorites that 
your Kids have access to. (The default 
group is Kids, but it will be grayed out if 
you haven’t set up that group.)

You can press the Side Key next to 
Pick Favorites and choose a different 
favorites group that you want your 
Kids to have access to, e.g., any other 
favorites group that you’ve set up.

After you’ve done this you now have the 
option to Turn KidSafe On. If you turn 
KidSafe On everything in the remote 
except access to the KidSafe group 
(and Volume/Mute keys) is locked out. 

No settings can be changed, and the Channel Up/Down and 
number keys will not work.

If you try to access any other favorite group, change a setting, 
or access any forbidden menu, you are asked to enter the 
KidSafe code. You cannot continue unless you enter the correct 
KidSafe code. See the Troubleshooting section if you forget 
your KidSafe code - but don’t let your kids read this owner’s 
manual!