16
17
When triggering an X10 module or wall switch using the
IR34A IconRemote, the signal is typically sent from the
remote using RF on a specifi c house code. The RF signal is
received by the transceiver (either TM751, RR501, CM15A, or
security console) on the matching house code. The transceiver
then forwards the signal onto the house wiring. This is now a
PLC signal. Any modules that match the house and unit code
transmitted will either turn on or off, depending on the signal
sent.
Setting Up the IR34A to control the TM751
Transceiver using Housecode “B.”
The TM751 Transceiver receives RF signals to
control lights and appliances. Do the following
to setup this transceiver.
• Press the
HOME
key to display the setup
screen. Select
Setup
.
• Select
X10
.
• Select
Add/Edit
at the next screen.
• Choose the room where you will locate the TM751.
For this example choose
Basement.
•
Press the Side Key to select.
• At the
add an X10 device
screen, press
OK
.
• Select
Pick Device
.
• Select
Appliances
and then scroll until you see the
TM751
icon. Select
TM751
using the appropriate Side Key.
• At the following screen select
Address
.
• Using the Side Keys, select “
B.
”
• Select
Save
using the Side Key.
• Select
Done
using the Side Key.
• Select Mode Button then the X10
device icon side key.
• Next select the room that you’ve set
the device in (Basement).
• Press the icon to test the RF
transmission for the device.
Setting Up X10 Devices, cont.
In the following example we’ll set up the remote for an LM465
Lamp Module located in the
“Basement.”
• Press the
HOME
Button to display the Home screen.
• Select
Setup
using the Side Key.
• Select
X10
using the Side Key.
• Select
Add/Edit
at the next screen using the Side Key.
• Select
Basement
(for this example) using the Side Key.
• At the
Let’s add an X10 device
screen, press the
OK
key to
continue.
• Select
Pick Device
and at the next
screen select
Lamps
using the Side
Keys.
• Go through the following screens to
fi nd the correct module using the
Next
Side Key.
• Select the LM465 Module by using the
Side Key.
• Press
Save
using the Side Key.
• Select
Address
using the Side Key.
• Use the Side Keys to set the values to
B3
.
•
Note:
The values in the Address screen must match the
physical hardware settings for the LM465 Lamp Module. In
this example, the settings are set at B3. This means that B3
matches the physical settings at the Lamp Module. (See the
following example on page 18 for setting up a Lamp Module
to a B3 setting.)
• Press
Save
using the Side Key to save the values.
• Select
Pick Logo
using the Side Key and choose an appro-
priate image by using the
Next
Side Key, and then select the
image by using the Side Key.
• Press
Save
and
Done
using the Side Keys.
Setting Up X10 Devices, cont.
Summary of Contents for IconRemote IR34A
Page 1: ...Model IR34A IconRemote Owner s Manual...
Page 28: ...54 55 Notes Notes...