5
4
The Direct Connect System
includes the
CM19A
USB Transceiver. It is used when
you want to directly connect your computer’s
RCA audio and video jacks directly to your
TV or Home Theater system.
Go to page 6 if you have this system.
The Wireless A/V System
includes the
VT42A
Wireless Audio/Video Sender with
built in USB Receiver. It is used for
computers that have an RCA or s-video type
Video out jack, which you can connect to the
VT42A. You can send the audio and video to
a remote TV or Home Theater system using
the VT42A.
Go to page 8 if you have this system.
The Wireless VGA System
includes the
VT37A
Wireless Audio/Video VGA Sender
with built in USB Receiver. This system is
used for computers that don’t have an RCA
Video out jack. You can see
Lola
on a Remote
TV/Home Theater system, and hear your
Music on the remote TV as well.
Go to page 10 if you have this system.
G
ETTING
S
TARTED
In order for everything to work, it’s important that you follow these steps
before setting up the rest of
Lola
.
Install the
Lola
Lola
Lola
Lola
Lola
Software
The first step to installing
Lola
is to install the software from the X10 web
site. Use the link in the e-mail (subject “New Software Download Link”)
that was sent to you shortly after you placed your order.
Follow the instructions on screen as
Lola
is installed. When the installation
program asks you to connect it, plug the USB Receiver into a USB port on
your computer. Depending on which kit you purchased the USB Receiver
will look different. It has a plug on it that looks lie this:
Windows® is a registered trademark of Microsoft Corporation.
Model CM19A
Model
VT42A
Model
VT37A
S
YSTEM
T
YPES
Which system do you have?
All three system types look similar but the pictures here will help
distinguish which one you purchased.
Install the batteries in the Remote.
Push the tab and lift off the battery cover.
Insert four AAA alkaline batteries, taking
care to match the + and - marks in the battery
compartment. Press PC on the remote.
When you plug in the USB Receiver, Windows will tell you that it has found
new hardware and the installation will continue automatically. When it’s
done, continue on with the rest of the
Lola
setup. When it’s finished
installing, run
Lola
the Windows
®
Start button.
Note: Place the USB Receiver as far away from your computer and its
monitor as its cord allows.
