X10 MT10, Owner'S Manual

MT10E_08/97

10

Setting a timed event to occur in the “Security” mode

If you advance to a specific time, and then press one of the ON or OFF rocker keys, you
will set an on or off time for that Unit Code to occur every day at exactly the same time.
If however, you press the “Security” button within 4 seconds after setting an ON or OFF
time, you will modify the program for that particular Unit Code to occur every day at a
slightly different time each day.

The event you have programmed will happen at the time you have programmed on the
first day, and will then happen at a different time on each subsequent day (within the
hour you have programmed). For example:

If you advance to 7:35 PM, press the ON rocker key for number 2 and then press the
“Security” button (within 4 seconds), the Module(s) set to Unit Code number 2 will go on
at exactly 7:35 PM on the fist day and any time between 7:00 PM and 8:00 PM every
day after that.  This time will vary each day so that the Module doesn’t go on at the same
time each day (to give your home a lived-in look).

Sleep function

Set the Mode Switch to “Run.”

To Turn a Module ON for 15 mins Press the ON rocker for the desired Module, then
press the “Sleep” button (within 4 seconds).  The Module will turn on immediately and
will turn off automatically 15 minutes later. If you press the Sleep button twice, the
Module will turn off 30 minutes later, 3 times gives 45 minutes.

To turn a Module OFF for 15 mins Press the OFF rocker for the desired Module. Then
press the “Sleep” button (within 4 seconds).  The Module will turn off immediately and
will turn on automatically 15 minutes later.  If you press the Sleep button twice, the
Module will turn on 30 minutes later, 3 times gives 45 minutes etc.  Press it as many
times as you like.

You can have up to 2 Sleep times in operation at the same time.  i.e. Module number 1
could go on now and off 30 minutes later and module number 2 could go off now and
on 45 minutes later.

Programming ON and OFF times