7
6
Installation
Security Remote
Registering the Security Remote with the Security Console
• Set the code wheel on the Security Remote to the same House Code as the Security
Console.
• Fit four AAA Alkaline batteries in the battery compartment in the back of the remote.
• Set the slide switch on the Security Console to INSTALL.
• Press ARM on the remote. The console beeps once to confirm that the remote has
been registered.
• Return the console slide switch to the RUN1 or RUN2 position.
Note: If the remote did not register, remove the label on the front and use a pencil or
other pointed object to press the small CODE button to generate a new random code.
Press ARM again to install the remote.
Testing the Security Remote
• Set the slide switch on the Security Console to RUN1 or RUN2.
• Press ARM AWAY on the remote. The console beeps once to confirm and the ARM
indicator lights. Press DISARM.
• Press SECURITY LIGHT ON and OFF to control a light connected to a lamp module
with codewheels set to the same House Code and Unit Code as set on the Security
Console.
PANIC PANIC
ARM DIS-
HOME ARM
ARM DIS-
AWAY ARM
SECURITY
LIGHT
ON OFF
A
I
E
M
O
C
G
K
•
•
•
•
•
•
•
•
INSTANT
DELAY
BRIGHT DIM
ENTRY
Installation
Security Console
Mounting the console
The Security Console is designed to be installed free-standing on a table top or shelf.
A wall mounting bracket is also available.
Fitting the backup battery
Slide off the battery compartment cover and clip a 9V battery onto the battery contacts.
Slide the battery into the battery compartment and replace the cover. When AC power is
applied the battery LED on the front panel will go out. It is not necessary to disconnect
power to the console when fitting or replacing batteries.
Attaching cables
A telephone cord terminated at each end in an RJ11 connector is provided for telephone
connection. If possible, the console should be connected to its own telephone line to
ensure that the line cannot be busy when the console attempts to dial out. For
applications where this is not practical, the console may also share a line with an
existing telephone using a 'T' adapter.
Note: The X10 Security Console is not designed to operate with an RJ31X type
telephone connection.
