X10 SUPERREMOTE UR24A, Owner'S Manual

31

30

You cannot store any functions under the
following keys:

L

earn

Setup
TV
VCR
Cable
SAT
CD
AUX1

AUX2
X10
Timer
Enter
Shift
Shift Learn
Shift Setup
Shift TV

Shift VCR
Shift Cable
Shift SAT
Shift CD
Shift AUX1
Shift AUX2
Shift X10
Shift Timer

You cannot stor

stor

stor

stor

store 

e 

e 

e 

e two products under the

same key using shift, i.e. you can’t enter
the 3 digit code for a VCR and then
press shift and enter another 3 digit code
for another VCR. But you can lear

lear

lear

lear

learn 

n 

n 

n 

n a

second product using SHIFT as follows.

e.g. For two VCRs:

Press SETUP, VCR, then enter the 3 digit
code for your first VCR (see page 14 for
more details).

For VCR2:

Press SETUP, VCR, LEARN.

Then press SHIFT, then Play (on the
UR24A) then Play (on the original VCR
remote).

Then SHIFT, then Stop (on the UR24A)
then Stop (on the original VCR remote),
etc.

Then Enter.

Then to access each VCR:

Press VCR on the UR24A and the
appropriate key on the UR24A to access
the first VCR.

Press VCR and then Shift, and then the
appropriate key to access the second
VCR. You can keep pressing keys and
you will stay in the “shifted mode” for
about 10 seconds. You will time out of
the shifted mode about 10 seconds after
the last key is pressed.

6.

Press the button on
your existing
remote that you
want to learn. Hold
the button until the
LED on the UR24A
SuperRemote blinks
off.

7.

Repeat steps 5 and 6 for each button
you want to learn.

8.

When you’ve
finished learning all
the keys, press
ENTER.

Notes:

Make sure you have fresh batteries in
both remotes before learning.

Take care not to move either remote
while pressing the buttons.
Experiment with the distance between the
remotes if you have a problem learning.

Some remotes do not have their LED in
the center so you might need to
experiment with the side-to-side position
of the remotes relative to each other.
Do not sit directly under an incandescent
lamp while teaching the Learning
SuperRemote.

In most cases you will hold the button on
the remote you are learning from until the
LED goes out on the Learning
SuperRemote. In some cases however,
you might find that the LED on the
Learning SuperRemote doesn’t go out
until you release the key on the remote
you are learning from.
Use buttons L1 and L2 to learn codes for
which the Learning SuperRemote does
not have a corresponding button.

If you have problems learning keys, try a
Master Reset (Page 12) and then try
learning them again.