9
8
1.
Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2.
Plug a lamp into
the Lamp Module.
3.
Plug the Lamp
Module into a
convenient AC
outlet.
8-
IN
-1 L
EARNING
S
UPER
R
EMOTE
The 8-in-1 Learning SuperRemote allows
you to control practically everything
electrical in your home. It combines IR
technology that lets you control all your
TV, VCR, Cable and Satellite equipment
with X-10 RF technology that lets you
control lamps and appliances anywhere
in your home.
To find out more about configuring the
Learning SuperRemote to work with your
audio/video equipment, see the section
titled “Setting Up your SuperRemote.”
1.
Push the tab and lift
off the battery
cover.
2.
Fit four AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
I
NSTALLING
THE
C
OMPONENTS
T
RANSCEIVER
M
ODULE
The Transceiver Module receives radio
frequency (RF) commands from
remotes to operate a lamp or
appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X-10 Modules. Note that
unlike the Lamp Module you cannot
dim and brighten a lamp connected to
the Transceiver Module.
You should locate the Transceiver
Module centrally in the home for
maximum range when controlled by
the X-10 Learning SuperRemote.
2.
Plug a lamp or
appliance into the
Transceiver
Module.
3.
Plug the
Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
L
AMP
M
ODULE
The Lamp Module may be used to
control any incandescent lamp rated
up to 300W. It is not suitable for other
types of lamp such as fluorescent or
energy saving lamps, or lamps which
include a dimmer control.
Caution:
Do not connect an appliance
such as a coffee pot or heater to the
Lamp Module. It may damage the
module and the appliance and could
cause a fire hazard.
1.
Set the House
Code to ‘A’ .
