Quick start guide
1) Put the batteries in
1.Open the cover on the back of the 8 in 1 remote control
2.
Insert 4 batteries (LR03 alkaline). Make sure the batteries are the same brand and are
NEW
2) Program your 8 in 1 remote control
1. Turn on the equipment that you wish to control (TV, VCR, DVD, SAT, CD etc ...)
2. Take the code book supplied with the remote control and find the brand of the equipment
you wish to control. E.g. if you have a Thomson TV look for Thomson under the TV
section.
3. Press on the key marked " SETUP " (4) pressing the key until the red LED stays
permanently bright. This takes about 3 seconds.
4. Press on the TV, VCR, DVD, SAT... mode key (5), in accordance with the appliance you
wish to control.
5. From the code book take the first number corresponding to your equipment and enter the
number by pressing the 0-9 key pad (10). Each time you press a key the red LED (1) will
flash.
6. If the number is correctly entered the red LED will switch off. If the number is incorrect
then the red LED will flash fast. If incorrect you will need to begin at 1.
7. Alternative to 5: If your brand is listed hereafter:
BRAND
CODE
BRAND
CODE
Philips/Radiola
1
Telefunken/Saba/Normende
4
Sony/Panasonic/JVC/
2
Grundig/Blaupunkt
5
Sharp/Akai/Toshiba/Daewoo
Thomson/Brandt
3
Nokia/ ITT
6
Enter the code corresponding to your brand, point the remote control in the direction of your
equipment, press once only (14) continue to point the remote control at your
equipment until the equipment changes channel. (The remote control sends an IR signal
every second. So please wait until your equipment reacts). When your equipment does
react, press on the key ENT (11) to confirm. If accidentally you miss the code, you can stop
the autosearch by pressing CHANNEL - (14) and by repeatedly pressing this key return to the
right code. Press ENT (11) to confirm.
8. Press on the key POWER (2). If your equipment switches off you have found the right
code. If it does not switch off, you will need to re-start from 3.
Sometimes there are several codes which have similar features. If you find that your 8 in
1 does not work for some functions, you may need to search for another code.
5
