STEP 1
Remove the fan(s) from the CPU cooler before installation.
INSTALLATION MANUAL
3
3. Installation guide for AMD
STEP 2
Place the screw stem
C
through the backplate
A
into the
designated holes, the backplate have multiple hole stand outs
which need to be checked carefully to select the right
configuration. Following fasten them with the nuts
F
.Then
insert the screw pad
H
.
STEP 4
Take the pre-assembled backplate and insert the screw stem from
the back of motherboard and through.
STEP 5
Place a small needle drop of the supplied thermal grease onto
the CPU cooler base or the CPU heat spreader and spread it out. Do not
use the whole supplied tube, this will be too much and result in a
lower cooling performance.
N
STEP 8
Install the fans onto the heatsink, connect the
Y-splitter cable to the fans and plug it into the mainboard CPU
cooler header. Please read your mainboard manual to locate the
correct CPU cooler fan header.
P
STEP 1
Remove the fan(s) from the CPU cooler before installation.
INSTALLATION MANUAL
4
3. Installation guide for Intel (except LGA 2011)
STEP 4
Place a small needle drop of the supplied thermal grease onto
the CPU cooler base or the CPU heat spreader and spread
it out. Do not use the whole supplied tube, this will be too
much and result in a lower cooling performance.
N
STEP 5
Place the heatsink onto the CPU and insert the placed screw stem
into the heatsink mounting bracket.
C
STEP 7
Install the fans onto the heatsink, connect the
Y-splitter cable to the fans and plug it into the mainboard CPU
cooler header. Please read your mainboard manual to locate the
correct CPU cooler fan header.
P
C
STEP 3
Take the pre-assembled backplate and insert the screw stem
from the back of motherboard and through.
STEP 3 (When utilizing a Socket K8 mainboard then you can skip this step)
Fasten the AMD retention bars onto the heatsink with the
supplied screws .
G
N
STEP 6
Place the heatsink onto the CPU and insert the placed screw stem into
the heatsink mounting bracket.
C
STEP 7
Fasten the supplied screws onto the stem and tighten them.
A rule of thumb is that you don’t need to tighten too fast.
On and solid secured is enough.
C
E
K8
AM2/AM3
STEP 2
Place the screw stem through the backplate into the
designated Intel holes, the backplate have multiple hole stand outs
which need to be checked carefully to select the right configuration.
Following fasten them with the nuts .Then insert the screw pad .
C
A
F
I
STEP 6
Fasten the supplied screws onto the stem and tighten them.
A rule of thumb is that you don’t need to tighten too fast.
On and solid secured is enough.
C
B