Installation instructions
Technical support
The X9RFATOPBAT is automatically recognized by
the computer and does not require a driver. Simply
follow the steps below and you are ready to go!
1. Charge the mouse when needed.
2. Use your fingernail to lift and separate the top
cover from the mouse, remove the USB RF
receiver dongle from its compartment slot. Place
the top cover back to the mouse securely.
3. Plug the USB RF receiver dongle into the USB
port of your computer.
4. Switch to turn on the mouse power, you are
ready to use the X9RFATOPBAT mouse.
Sync USB RF dongle with the mouse
Note:
only if you have followed the Installation
Instruction several times already but couldn't get
the mouse to work, or if you lost the original USB
RF dongle and get a new dongle from us, you can
resync the dongle and the mouse with procedures
below:
1, Preparation: boot up your computer, unplug the
USB RF dongle from your computer first if it was
plugged in.
2, Switch to turn off the mouse. Hold the mouse in
your right hand and use your right fingers to keep
pressing and holding down (hard enough to feel the
click) both the scroll wheel button and right mouse
button together while using your left hand to switch
to turn on the mouse, then after 3 seconds, release
your right fingers from the mouse buttons. Now the
mouse enters into the sync mode(sync light flashes
quickly), please note that you have 10 seconds only
to finish step 3 and 4 below.
3, Immediately plug the RF dongle into a computer
USB port. The dongle will start searching for a
mouse to sync, (normally up to 10 seconds it will
stop searching).
4, Promptly bring the mouse a few inches nearby
the RF dongle, the mouse should sync with the RF
dongle automatically. Test the mouse to see if it
works or not.
5, If it does not work, repeat step 1 through 4.
If you wish to configure the mouse settings to your
personal preferences you can do this in the settings
of the operating system:
Mac OS
To configure the tracking speed, scrolling speed,
double click speed and primary mouse button, go to
Mouse in System Preferences.
Windows
To configure the mouse buttons, pointer, pointer
options and wheel, go to Mouse in
Hardware/Control Panel.
Warranty
X9 Performance warrants that this product will be free from defects
in title, materials and manufacturing workmanship for one year
from the date of the purchase. If the product is found to be defective
then, as your sole remedy and as the manufacturer’s only
obligation, X9 Performance will repair or replace the product. This
warranty is exclusive and is limited to the X9RFATOPBAT. This
warranty shall not apply to products that have been subjected to
abuse, misuse,abnormal electrical or environmental conditions, or
any condition other than what can be considered normal use. The
liability of X9 Performance arising from this warranty and sale
shall be limited to a refund of the purchase price. In no event shall
X9 Performance be liable for costs of procurement of substitute
products or services, or for any lost profits, or for any consequential,
incidental, direct or indirect damages, however caused and on any
theory of liability, arising from this warranty and sale. These
limitations shall apply notwithstanding any failure of essential
purpose of any limited remedy.
In USA, please call to +1 909 230 6888, Monday through
Friday, 9AM to 5PM(Pacific time). or email to
techsupport@x9performance.com.
