1.
B
EFORE
S
TARTING
Find the power input on the right side of the terminal. Connect the plug from the power adapter into the power
input (Figure 1). Plug the power adapter into a 120-volt electrical outlet or into a surge suppressor
(recommended) after the power cord is connected to the power adapter.
Figure 1
Operating Temperature: 0
°
C to 40
°
C
RTC battery spec. : 3V, CR2032
Adapter: LITEON,PA-1061-71, I/P: 100-240Vac, 47-63Hz, 1.5A, O/P: 12Vdc, 5.0A
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery
according to the instructions.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord be
used.
2.
P
OWER
O
N
Plug the power cord into the power jack and plug the power adapter into a 120-volt electrical outlet or into a
surge suppressor (recommended) after the power cord is connected to the power adapter. Press the “Cancel”
button at the front of device (Figure 2) until the system is booted up.
Figure 2
3.
P
ORT
C
ONFIGURATION
There are several ports at the back side of TP72-HUB (Figure 3).
USB Host x 4
USB Device x 1
RS232 port x 1
Cash drawer port (RJ11)
Ethernet port (RJ45)
Figure 3
4.
L
OADING THE
P
APER
