Figure 3
Figure 4
Figure5
Figure 6 Figure 7 Figure 8
2. Power On The Terminal
Plug the power cord into the power jack and plug the power adapter into a surge suppressor (recommended)
and the device will boot on simultaneously.
3. Load The Paper
Gently pop the printer cover’s latch to open the cover (Figure 9); then lift the cover. Load a roll of thermal
paper (Appleton 1012 recommended) into the printer (Figure 10). Load it so that the print-side of the paper
will feed out facing the operator. Close the cover by pressing down evenly on both side tabs, or by pressing
on the center of the printer cover. Use the serrated bar to tear off any excess paper.
Figure 9 Figure 10
4. Using The Magnetic Card Reader
Secure Magnetic Card Reader
Find the card reader slot at the right side of terminal. Slide the card in either direction through the slot
without stopping. If the card swipe fails, check the position of the magnetic stripe and slide the card again
(Figure 11).
Figure 11
Caution:
Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery
according to the instructions.
Warning:
This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Caution
: Use only shielded signal cables to connect I/O devices to this equipment. You are cautioned that
changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.