59
XAG AUSTRALIA
Aircraft Response to Lost Connection with ARC3 Pro
The P100 Pro is designed to respond to lost connection with the Remote Controller in two different
ways, depending on the mode it's currently operating in: Autonomous Mode and Manual Mode.
Autonomous Mode:
Should your P100 Pro drone be operating in Autonomous Mode and experience a lost connection
with the Remote Controller, it's pre-programmed to persist with its ongoing task. Upon completion of
this task, or under two specific conditions - when the battery level depletes to the predetermined RTL
threshold, or when the drone's container becomes empty - the drone will activate the Return to Land
(RTL) procedure.
Manual Mode:
In Manual Mode, a lost connection triggers a different set of responses. The aircraft will first hover
in place for two minutes. If the connection is not restored within this period, the aircraft will start the
Return to Land (RTL) procedure. However, if connection with the Remote Controller is regained during
the initial hover or while it's returning to land, the aircraft will stop and hover, and waits for new input.
Please refer to the table below for a quick reference:
Mode
Aircraft Action
(Connection Lost)
Aircraft Actions
(If Connection is Restored)
Autonomous
Continue Task, then RTL
Continue Task, then RTL
Manual
Hovers for 2 min, then RTL
Hovers and awaits Command
Summary of Contents for P100 Pro
