XAG P20 2019, Quick Start Manual

Quick start guide

www.xa.com

16

•Precautions

1. The distance between your phone and the  CommBack shall be maintained at 20cm-10m, and it 
shall be noted that your phone shall not be too close to the  CommBack to avoid interference from 
your phone with the signal of  CommBack.

mort than: 20cm 

2. The CommBack antenna signal radiates in an "apple-like" emission. In order for the drone to obtain 
the best remote control signal, the CommBack antenna should be deployed to maintain the vertical
state, and the CommBack is held as shown below.

•Pairing the Aircraft

STEP 1 – When your Smart phone is wirelessly connected via Hotspot, access XPLANET or 

STEP 4 –

 XGEOMATICS App .

STEP 2 – Select Device, and click on “Pair”.

STEP 3 – Follow the on-screen instruction and Power on the UAV, and select the corresponding device  

STEP 4 –

 to be paired.

STEP  4  –  If  the  pairing  process  is  successful,  a  notification  will  appear  “Pairing  successful”,  and  the                                

STEP 4 –

 device will be displayed on the device interface.

STEP 4 –

 Repeat this process if the firmware update are unsuccessful

STEP 5 – Confirm the UAV is functioning normally by selecting the UAV and Select "USE" in deployment       

STEP 4 –

 of UAS, if it is displaying “IN USE”, the UAV is functioning normally.

STEP 4 –

 Note: Please be noted that pairing the aircraft requires sufficient Operator Level 

STEP 6 – Follow the on-screen instruction and Power on the UAV, and select the corresponding device 

STEP 4 –

 to be paired.

Only on the XAG member platform can a UAS with the right to use be successfully paired.

Atten