820-0332
4-1
System Operation
Controller Operation
ON-OFF Switch:
The ON/OFF switch turns power to the
controller ON and OFF. The POWER
LED will light when power is turned
ON.
Programable Thumbwheel Counter
Individual thumbwheel settings are
available to monitor the number of
Dots placed by an ink cartridge (Dots
X 1000). These three thumbwheels
can be set to any number of dots
between 1,000 and 999,000. A red
"STATUS" LED will be illuminated,
and an audible alarm will sound when
the programmed limit is exceeded.
For example, if you select 30,000 dots
(turning the "DOTS X 1000"
thumbwheel to 30) the "STATUS" LED will light when 30,000 dots have been deposited.
Upon installation of a new ink cartridge, it is recommended that the thumbwheels be reset
to alert the operator when a cartridge is nearing replacement. The “DOTS X 1000” setting
is programmed by using the RESET button. See RESET button for programming the
“DOTS X1000” setpoint.
Install the pneumatic controller in a location that is easily
accessible to the operator. The ON/OFF switch is the
pneumatic controller’s main power disconnect device and
must always be easily accessible.
WARNING
Summary of Contents for 340-7110
Page 10: ...1 2 820 0332 This page is intentionally left blank...
Page 18: ...Controller Installation Installation 3 6 820 0332 This page is intentionally left blank...
Page 34: ...Cartridge Priming Tips System Operation 820 0332 4 16 This page is intentionally left blank...
Page 40: ...Ink Removal Information Ink 820 0332 5 6 This page is intentionally left blank...