820-0332
7-1
System Specifications
DC Power Supply Requirements
The DC power supply received with your DieMark inking system meets these
requirements. Use only the DC power supply provided with the unit or an authorized
replacement power supply from Xandex Inc. or an approved Xandex distributor. For
the exact specification of your power supply, see the “24VDC Power Supply” drawing
included in your product manual drawing package.
Pneumatic Controller Specifications
Size:
6.5" x 6.25" x 4.25" (159mm x 159mm x 108mm)
Weight:
3.25 lbs (1.47 kg)
Input Power Requirement:
24V
⎓
(VDC) 0.84A
Foot Switch Input:
Contact Closure >50 msec
Air Consumption per
Regulator:
80 PSI
±
5 PSI Instrument Air per ISA 7.3 specification
<0.5 cfm @ 10 dots/second
Cycle Rate:
Exceeds 300 cycles/minute
Counters:
Eight Digit with External Reset (Independent of
Microprocessor)
External Regulator/Filter:
5.0 micron Air Filtration
Prober Input:
12 - 60 volts @ minimum 30 ms pulse width. The input
circuit presents approximately 1 K
Ω
- 700
Ω
input
resistance. Typical current as a function of input voltage
is listed in the following table:
15 V
20 V
40 V
60 V
25 mA
45 mA
65 mA
85 mA (Maximum input)
Input Power Requirement:
100-240 VAC
@ 50-60Hz
Output Power Requirement:
24V
⎓
(
VDC) / 0.8A or greater
Approvals:
UL / FCC / PSE / CCC / CE / WEEE / ROHS
Protection:
Overvoltage/Short Circuit
Output Pin Assignments:
Center: +V
Outside: Return
Output Plug Size:
Outside Diameter:
Inside Diameter:
Barrel Length:
5.5mm
2.5mm
9.5mm
Summary of Contents for 340-7110
Page 10: ...1 2 820 0332 This page is intentionally left blank...
Page 18: ...Controller Installation Installation 3 6 820 0332 This page is intentionally left blank...
Page 34: ...Cartridge Priming Tips System Operation 820 0332 4 16 This page is intentionally left blank...
Page 40: ...Ink Removal Information Ink 820 0332 5 6 This page is intentionally left blank...