kubi
Enhanced Audio Kit
KUBI SECURE INSTALLATION
KUBI SECURE INSTALLATION
INSTRUCTONS
INSTRUCTONS
NOTE:
NOTE: If you are installing the speak-
er bracket on an already assembled
kubi secure, remove the arms from
the kubi by removing the two arm
retention screws. Retain screws for
re-assembly.
Kubi Secure Arms are shipped
with foam pads attached. Two of
these pads (red arrows) must be
removed to install the Audio Kit
Speaker Bracket.
Peel the bottom two pads off of
the arms (red arrows in item 1) and
remove all adhesive from the arms.
An adhesive solvent may be
required, like acetone or Goo
Gone®.
Align the right arm over the thread-
ed insert on the kubi. Orient the
speaker bracket over the arm as
shown, and install one of the small
center-pin torx screws using the
kubi wrench. Wrench and screws
are supplied with the kubi (not the
audio kit).
Slide the left arm into place behind
the speaker bracket and align the
flat edge to the flat edge on the
right arm (red arrow in image #2).
Rotate the speaker bracket down
into place.
Install one of the small center pin
torx screws using the kubi
wrench.
After both screws are in place,
visually inspect the alignment of
the arms. They should be cen-
tered on the kubi housing with the
speaker bracket flat against the
arms.
Copyright © 2017 Xandex Inc. 1360 Redwood Way, Suite A, Petaluma CA 94954
TEL: (707) 763-7799 EMAIL: kubi@xandex.com For more infomation visit www.revolverobotics.com P/N 180-0135r1
