Tightening torque: 18 Nm
6. Add the requested amount of the
recommended final transmission oil,
and then install and tighten the oil
filler cap.
Recommended final transmission
oil:
Castrol Power 4T 10W40 or ATF Öl
Oil quantity: Full: 0,5 l / Change: 0,4 l
!
WARNING
• Make sure that no foreign material
enters the final transmission case.
• Make sure that no oil gets on the tire
or wheel.
7. Check the final transmission case
for oil leakage. If oil is leaking, check
for the cause.
Change final transmission oil
1. Start the engine, warm up the final
transmission oil by riding the vehicle
for several minutes, and then stop
the engine.
2. Place the vehicle on the main stand.
3. Place an oil pan under the final trans-
mission case to collect the used oil.
4. Remove the oil filler cap (2) and
drain bolt (3) to drain the oil from the
final transmission case.
1
2
3
5. Install the final transmission oil drain
bolt, and then tighten it to the speci-
fied torque.
COOLANT
Before you start operating the vehic-
le, check the coolant level. The radi-
ator should be completely filled with
coolant. The reservoir is located right
in front of the tank fixed to the frame.
In the expansion tank, the coolant
should be between the MIN and MAX
mark stand.
Recommended coolant:
CASTROL RADICOOL PREMIX
CAUTION
The new filling and bleeding of the coo-
ling system should be carried out by a
dealer.
AIR FILTER
The air filter should be replaced ac-
cording to the maintenance schedule.
Replace the air filter more often if you
drive in unusually wet or dusty areas.
32
PERIODIC MAINTENANCE AND MINOR REPAIR