9-16 Options
bb
___________________________________________
c.
Tilt the SIMM forward towards you to a 45˚ angle and
slide it up and out of the bank (fig. 9.13).
d.
Remove the upgrade SIMM from its protective bag.
e.
Align the new SIMM at a 45˚ angle toward you (with the
notched corner down and to the left) over the appropriate
bank (fig. 9.13). Then insert the SIMM into the bank’s
connector.
45
°
90
°
Notch
Fig. 9.13 Installing a SIMM
Caution:
A SIMM only fits in one direction. Do not
force a SIMM in place. If it does not go in
easily, realign it making sure that the
notched corner is down and to the left and
that the SIMM seats correctly in the bank.
f.
Gently push the SIMM toward the back and up to a 90˚
angle (fig. 9.13) until the two bank latches snap in place
in front. You may have to hold the two latches out while
pushing the SIMM into place, and then release them.
g.
If you have another SIMM to install repeat steps a
thorough f. If not, go to step 10.
