2-16 Installation
bb
_________________________________________
4.
Remove the printer’s back cover. First, push the cover slightly
to the left (fig. 2.9; 1); then gently pull it out from the right
side (fig. 2.9; 2).
Note:
Store the original cover in a safe place so you can
replace it later if you remove the duplexer.
1
2
Fig. 2.9 Remove the Printer’s Back Cover
5.
Install the replacement back cover (included with the duplexer).
First, insert the cover’s left bottom tab into the slot on the printer;
then, push the cover right as far as it can go (fig. 2.9).
6.
Replace the spacer by positioning its bottom hook around the
cover’s left bottom tab and swinging the spacer down until it
snaps securely into the back cover (fig. 2.10).
Fig. 2.10 Replace the Spacer
