__________________________________________ Installation 2-23
Warning:
The printer weighs approximately 33 lbs (15 kg)
without the toner, media, and cassette installed. Have
someone help you lift it.
7.
Hold the printer as shown in figure 2.15 and lift it up and off
the duplexer.
8.
Realign the back unit over the rear of the duplexer, making sure
the pointers line up; pull up the back unit’s top and back cover
latches; then, lower the unit onto the duplexer (fig. 2.19).
9.
Hold the back cover latch up (open) while you slide the back
unit until it closes firmly into place.
10.
Remove the back replacement cover from the printer by
pushing it left slightly, and then gently pulling it out from the
right side first (fig. 2.9).
11.
Replace the printer’s original back cover by inserting the
cover’s left bottom tab into the slot on the printer, and then
pushing it right as far as it will go.
12.
Replace the spacer by positioning its bottom hook around the
cover’s left bottom tab and swinging the spacer down until it
snaps securely into the back cover (fig. 2.10).
13.
Close the printer’s back cover and place the paper cassette
back into the printer.
14.
Reattach the interface and power cables to the printer.
15.
Plug the printer’s power cable into the power source.
Storing the Duplexer
Store the duplexer with the replacement back cover and cable guide
in its original box with the packing materials around it. The storage
location should maintain a 10˚ to 35˚ C (50˚ to 95˚ F) temperature
and a 10% to 80% relative humidity.
