8 Repacking Procedure __________________________________________________________________
2.
Disconnect the duplexer cable (fig. 21) and lift the duplexer off of the printer and set the duplexer
on its back (fig. 22).
Fig. 21 Disconnect the Duplexer Cable
Fig. 22 Remove the Duplexer
3.
Insert the duplex access panel’s top tabs into the notches on the top of the fuser cover; rotate the
access panel down and snap its bottom tabs into place (fig. 23); then, make sure the fuser cover is
closed securely.
Caution:
To prevent burns and paper jams, do not use the printer with the duplex access panel
removed unless the duplexer is installed.
Fig. 23 Replace the Duplexer Panel
4.
Repack the Duplexer in its original packing.
Note:
If you are not shipping the duplexer, store it in a location that meets the guidelines for
storing the printer (see your printer user’s guide).
Packing the Printer
If you no longer have your printer’s original packing materials, you can order a replacement set. Contact
either XANTÉ Customer Support (800-540-7091 in the US or Canada or 334-473-6502 elsewhere) or
your XANTÉ vendor. You will need a roll of heavy-duty packing tape.
Caution:
Damage resulting from incorrect packing voids your printer warranty. To keep the warranty
valid, you
must
follow the packing procedure in this document.
1.
Make sure all the printer’s covers are closed completely and tape the top cover and multipurpose
feeder shut.
