background image

IR Receivers

1

INSTALLATION INSTRUCTIONS

172-77

XTRA LINK

®

 2

REMOTE CONTROL EXTENSION SYSTEM

The Xtra Link 2 system provides full remote control operation of a satellite receiver, cable box or VCR from
a second room by sharing the coaxial cable connecting your video equipment to this second room’s TV.

The 172-77 Xtra Link consists of the following supplied parts:

1. An infrared Receiver, Model 291-00. It is placed at the

remote room location to receive IR signals from the
handheld remote controller.

2. One INJ77 Injector.  This unit, located in the Remote

Room, injects the remote control signal into the room-
to-room coaxial cable (along with the TV signal) and
passes it to the CPL77 Coupler in the Main room.  It
also provides quick connection of the 291-00 IR Re-
ceiver and 781C-77 Power Supply cables.

3. One CPL77 Coupler.  Located in the Main Room, this

Coupler extracts the remote control signal from the
coaxial cable and passes it to the emitters that control
your source equipment.  In addition, the CPL77 con-
tains a 2-way RF splitter so that the TV signal can be
fed to a local TV.

4. One Dual IR Emitter, Model 284M. The emitters on this device allow control of two infrared remote

controlled audio/video components.

5. A 781C-77 Power supply. This plugs into an unswitched 220-240 VAC outlet to provide power to the

291-00 IR Receiver.

CONNECTIONS

The Xtra Link system uses the coaxial cable that
carries the TV RF signal from the source equip-
ment in the main room to the remote room, to
send  the IR control signals back to the source
equipment.  The coaxial cable may be up to one
mile in length.

If you already have a coaxial cable connecting
your video equipment with a remote room, your
current hookup should be similar to 

Fig. 1

.  If it

isn't, run a single length of RG59 or preferably
RG6 cable from the Main Room to the Remote
Room.

NOTE:

 If RF amplifier(s) are used anywhere in

the line of coaxial cable between the CPL77
Coupler and the INJ77 Injector, you must use a
Xantech BYPASS77 KIT to route the IR com-
mands around the amplifier(s).

781C-77

Power Supply

284M

Dual Mouse Emitter

Front View

Side View

IR RECEIVER

INJ77 INJECTOR

ANT INPUT

+12 V

REMOTE TV

EMITTER

LOCAL TV

CPL77 COUPLER

SA

T/VCR

T

O

 TV

SIDE VIEW

SIDE VIEW

291-00 IR Receiver

172-77 Xtra Link 2 System Parts

Fig. 1 

 Basic System Without Xtra Link

Satellite Dish

REMOTE ROOM

RF IN

MAIN ROOM

Room-to-Room Coaxial Cable

RF IN

OUT TO TV

SATELLITE RECEIVER

(Back Panel)

RF IN

VCR

(Back Panel)

OUT TO TV

Coaxial Cable

1ST

TV

RF SPLITTER

2-Way

Coaxial Cable

Coaxial Cable

2ND

TV

RF IN

Reviews: