Model BXAUDIO4X4
Page: 31
© 2005 Xantech Corporation
SECTION 8.0: OPERATING INSTRUCTIONS
With all system components connected and the BXAUDIO4X4 Controller and Keypads programmed, The
system is ready for use.
5
2
3
1
4
9
10
6
7
8
11
12
13
14
1
5
2
3 4
6
7
9
10
11
12
LC4KP Keypad Button Layout
MRCREM Remote Button
Layout
Zone Control
Controlling the BXAUDIO System can be done in two ways within the Zone; either by pressing buttons on the
LC4KP Keypad or by using the MRCREM Zone Companion Remote. The MRCREM comes pre-programmed
out-of-the-box to access and control all of the macro’s within the BXAUDIO system.
It is basically a keypad in your hands.
MRCREM Remote:
Point the MRCREM at the LC4KP’s IR Receiver
[14],
press any of the corresponding numbered buttons on the
remote to trigger the Macro stored under the BXAUDIO’s LC4KP Keypad Button.
Note:
Source buttons labeled 5 thru 8, Memory Preset buttons M1 thru M4 and the ENTER button are non-
active when used with the BXAUDIO4X4.
To Control the Zone with the LC4KP Keypad and/or the MRCREM Remote, follow the steps below:
1. Press the ”POWER” button on any keypad or MRCREM remote
[5]
. The BXAUDIO4X4 Controller will turn
ON. If Power Management has been enabled, source components will turn on also.
2. Select a Source
[Buttons 1 thru 4]
. Operate the source with the appropriate commands (PLAY STOP
PAUSE etc…) etc)
3. Adjust the VOLUME to a suitable listening level using the Volume UP and Volume Down Buttons
[Buttons
9 & 10]
4. MUTE and UN-MUTE the Speakers
[11]
.
5. Change
Sources
[Buttons 1 thru 4]
.
6. Press “POWER” again and the zone will turn OFF
[5]
. If power management has been enabled, when the
last zone turns OFF, the source components will turn OFF as well after a 10 second delay.