08905153A
-
20
-
D5KP Speaker Connections
The D5RH routes digital audio to connected D5KP Amplifier Keypad where the audio is then
amplified and sent to in-room speakers.
WARNING!:
The D5KP’s amplifier is capable of powering a single pair of 8-6 Ohm speakers.
DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more than one speaker to either speaker
connector of the D5KP. In doing this, damage to the D5KP may occur and will void the products warranty.
To connect speakers to D5KP Amplifier Keypad:
1
Ensure that system power is OFF!
2
Remove the SPEAKER CONNECTOR from the D5KP Amplifier Keypad
3
Strip speaker wire back 1/4"
4
Loosen speaker terminal screws on the speaker connectors
5
Insert speaker wires into terminals making sure to ma/- polarity
6
Tighten screws on speaker terminals
7
Re-connect the terminal strip to the SPEAKER CONNECTOR on the D5KP Amplifier Keypad
8
Connect speaker wires to the room speakers maintaining correct polarity
Figure 3.8: Speaker Connections