Xantech ELAN Xtranet XLIP232, Integration Note

2 of 11 

Installation Overview 

1.  During the rough-in phase, pull Cat5 from the XANTECH XLIP location back to the System 

Enclosure. 

2.  If using RS-232 from the XANTECH XLIP, and the XANTECH XLIP is a distance from the equipment, 

then pull Cat5 from the equipment to the location of the XANTECH XLIP. 

3.  If using RS-232 from the XANTECH XLIP, install and connect the RS-232 equipment to the 

XANTECH XLIP.  

4.  If using IR from the XANTECH XLIP, install the equipment that will be controlled by the XANTECH 

XLIP, and run IR flashers back from each piece of equipment to the XANTECH XLIP. 

5.  If more than two IR outputs are needed, then install additional XANTECH XLIP units. 

6.  Configure the XANTECH XLIP using its built-in web server or The Xantech XLIP Java Utility 2.20.  

See 

Configuring the XANTECH XLIP

 below. 

7.  Connect the XANTECH XLIP to the 

g!

 system electrically. 

8. Configure 

the 

g! 

system

for the XANTECH XLIP.  Refer to 

Using the XANTECH XLIP with g!

 and 

g! 

System Configuration Details

 below.