Model MRC88m / MRAUDIO8x8m
Page: 53
© 2009 Xantech Corporation
D
ELETE
K
EY
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE KEY from the pop-up menu will delete ALL commands placed under the
selected
button from the current Keypad only. In BASIC Mode this applies to all keypads in the system.
D
ELETE
B
ANK
(Z
ONE
L
EVEL
)
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE BANK from the pop-up menu will delete ALL commands placed under all buttons of
the
selected
source bank from the current Keypad only. In BASIC Mode this applies to all keypads in the
system.
D
ELETE
A
LL
(S
YSTEM
L
EVEL
)
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE ALL from the pop-up menu will delete ALL commands placed under ALL buttons from
ALL of the keypads in the system.
P
UNCH
(Z
ONE
L
EVEL
)
(BASIC/ADVANCED/EXPANDED)
Selecting PUNCH from the pop-up menu will make the functions under
that
button available no matter
which Source is selected. This will copy that button macro to the same button under each of the 8 source
banks for
that
Zones Keypad. This can be useful for controlling a lighting scene, thermostat control or
opening/closing shutters in that zone. This type of function would need to be accessible regardless of
which source is currently selected in that zone.
P
UNCH
A
LL
(S
YSTEM
L
EVEL
)
(ADVANCED/EXPANDED)
Selecting PUNCH ALL from the pop-up menu will copy the entire current Keypad (buttons/commands under all
Source Banks) to ALL 8 Keypads in the system (16 Keypads for EXPANDED systems). This can be done after
all basic source component functions have been entered into a single keypad (i.e. a DVD’s PLAY, PAUSE, and
STOP button). to save time entering the same commands onto all Keypads.
C
OPY
(BASIC/ADVANCED/EXPANDED)
Selecting COPY from the pop-up menu will copy all commands placed under the highlighted button to the
clipboard for Pasting to another button.
P
ASTE
(BASIC/ADVANCED/EXPANDED)
Selecting PASTE from the pop-up menu will copy the commands placed on the clipboard (during the
COPY command) to the currently highlighted button.
EDITING COMMANDS (IN THE MACRO COMMAND LIST WINDOW)
Right-clicking on a command placed in the Macro Command List window will bring up a pop-up menu allowing
an individual command to be deleted, routed to a specific Zone emitter output or to a Source emitter output (see
Figure 27
above). Each of the functions available are described below.
