Page: 60
Model MRC88m / MRAUDIO8x8m
© 2009 Xantech Corporation
(BASIC)
In basic mode, the code group can only be set for the entire system. To change the Code Group, click on the
drop-down menu in the “SYSTEM CODE GROUP” box and select one of the displayed Code Group choices.
(ADVANCED/EXPANDED)
Each zone of the MRC88m can be set to it’s own individual Code Group. This may be useful when the system
requirements so dictate. (i.e. The system requirement calls for having zone-specific remote controls). Since
other Xantech IR controlled models are assigned and preset at the factory to different Code Groups, special
care should be taken when changing code groups to avoid accidentally changing another products code group
number or having the wrong product respond to an IR code intended for a different model.
1.
Click the ‘OPTIONS’ button in the bottom of the Virtual Keypad window.
2.
In the SELECT ZONE box, click on the zone to be edited
3.
In the RC68 GROUP CODE box, click on the drop-down menu and select one of the displayed
Code Group choices.
4.
Repeat for all zones
PRE AMP VOLUME ADJUST SETTINGS
(ADVANCED/EXPANDED)
This feature allows the PreAmp output for the associated zone to be
Variable
and follow the Volume setting for
the entire Zone (track 1:1 with default MRC88m Volume controls on Keypad or RC68 commands via remote) or
to be a
Fixed
output level to be controlled outside of the system. This may be desirable for individual Sub-Zone
control. Default for this setting is VARIABLE.
IR LOOP BACK SETTINGS
(ADVANCED/EXPANDED)
This feature enables/disables the In-Zone Emitter output located on the rear of each zones Keypad. When
enabled, IR codes received via the Keypads IR Sensor and IR generated from any Keypad routed to the Zone,
will be sent to this output. This feature can be used to control local (in zone) A/V components such as TV, DVD
player, or in-room lighting/thermostat control located in the same location as the keypad. Default for this setting
is DISABLE.
1.
Click the ‘OPTIONS’ button in the bottom of the Virtual Keypad window.
2.
In the SELECT ZONE box, click on the zone to be edited
3.
In the IR Loop-Back Settings box, select Loop-Back ENABLE or DISABLE.
4.
Repeat for all zones
NOTE:
For any IR commands generated from a Keypad intended to be
Looped Back
to the Zone or to be
output the Zone IR, you must first select the zone to be looped back to by right-clicking on the command in the
Macro Command List and selecting the appropriate zone under
Ir In Zone
. Usually you will want this set to
CURRENT ZONE. See
Figure-32
below.
