Page 4
Model SPLCDCB100
© 2004 Xantech Corporation
HIGH IR OUT WIRING:
The HIGH IR OUT wiring is for emitter expansion to Xantech’s 790-00 passive Connecting Block. Up to nine 790-00
Connecting Blocks can be combined for a total of 100 emitter ports.
1. Use a Mono Mini cable from the SPLCDCB100 High IR Out connector to either of the two HIGH IR IN/OUT
connectors on the 790-00 Connecting Block.
Note:
See the 790-00 Instructions for further details.
CAUTION:
The High IR Out jack should only be used when expanding to the 790-00 connecting block.
Do Not
Connect Emitters or IR Receivers directly to this jack!
SPLCD-CB
Amplified Connecting Block
790
Connecting Block
E M I T T E R S
HIGH IR
IN / OUT
SIG
790
CONNECTING BLOCK
®
HIGH IR
GND
GND
HIGH IR
IN / OUT
E M I T T E R S
16 VDC
IR
RCVR
SPLCD-CB
AMPLIFIED
CONNECTING BLOCK
®
+12 VDC O
UT
GND
ST
A
TUS
IR IN
HIGH
IR
OUT
SPLCD
ONLY
+16 VDC
GND
ST
A
TUS
IR IN
IR TB
Fig. 3 – Expansion Emitter Wiring: Connecting the SPLCDCB100 to the 790-00
XANTECH CORPORATION
13100 Telfair Avenue, Sylmar CA 91342-3829
phone 818.362.0353 • fax 818.362.9506
Part No. 08905010 Rev B 11-16-04
