5
Controllers
9/12/95
Fig. 5
RESET button
RESET
TROUBLESHOOTING TIPS
Batteries
• The URC-1 most easily learns commands from other remote controls when they have strong batteries.
As the teaching remote controller battery weakens, the strength of it's signal weakens -- making it more
difficult for the URC-1 to learn the commands.
• If you have any difficulty with the URC-1 learning commands, make certain you have fresh batteries in
the teaching controller.
Lock-Up
• On rare occasions, a condition known as "lock-up" may occur when learning commands. The LEARN LED
will flicker continuously and the ERROR LED may stay on. Pressing the LEARN button will have no effect.
•
To clear a lock-up, remove one of the batteries for about 10 seconds
.
• CAUTION: If you leave the battery out for more than 2 or 3 minutes, all programming will be lost.
RESET Button
• The RESET button is located in the Battery Compartment as shown in Fig. 5. If you have persistent trouble
with lock-ups or learning certain commands, you may wish to clear all stored commands from the URC-
1. To do so, press this button for 5 seconds.
• Remember, if you use the RESET button, all of the programming information you have entered will be
erased. There is no way to restore this information except by re-programming.
URC1
