2. Plan where to mount the charge controller, fuses, and cable locations.
a.
Identify and gather information about your vehicle.
- Some vehicles are factory-installed with roof cable entry
points.
- If a cable entry point is absent, factory-installed vents can be
used to route cables through.
b.
Locate a suitable location for the charge controller inside the
vehicle. Select an area that is readily accessible, viewable, and
free from exposure to moisture.
c.
Plan the route and measure the lengths of cables needed to
reach their connection points factoring in bends and slack.
d.
You may add additional solar panels. For more information,
see
.
WARNING
ELECTRIC SHOCK AND FIRE HAZARD
Do not ground any PV conductors.
Failure to follow these instructions can result in death,
serious injury, or equipment damage
.
PWM 30A Charge Controller (PN: 709-3024-01)
MPPT 30A Charge Controller (710-3024-01)
7
975-1029-01-01 Rev F
February 2024
