iv
Freedom Sequence Intelligent Power Manager Installation Guide
Important Safety Instructions
IMPORTANT:
R
EAD
AND
SAVE
THIS
I
NSTALLATION
G
UIDE
FOR
FUTURE
REFERENCE
.
This chapter contains important safety instructions when operating the
Freedom Sequence Intelligent Power Manager. Each time, before using the
Freedom Sequence Intelligent Power Manager, READ ALL instructions
and cautionary markings on or provided with the power manager and all
appropriate sections of this guide.
NOTE:
The Freedom Sequence Intelligent Power Manager contains no user-
serviceable parts. For obtaining service, see “Warranty and Return
Information” on the Owner’s Guide for guidance.
NOTE:
The Freedom Sequence Intelligent Power Manager must be provided
with grounding conductors connected to the AC input/output connections.
NOTE:
The power manager has no on/off switch. Circuits are always live
when DC and AC input are present.
ELECTRICAL SHOCK HAZARD
•
Do not expose the power manager to rain, snow, spray, or bilge water.
•
Do not operate the power manager if it has received a sharp blow,
been dropped, has cracks or openings in the enclosure, or will not
close, or otherwise damaged in any other way.
•
Do not disassemble the power manager.
•
Disconnect both AC and DC power from the power manager before
attempting any maintenance or cleaning or working on any circuits
connected to the power manager. See note below.
•
Do not operate the power manager with damaged or substandard
wiring. Make sure that all wiring is in good condition and is not
undersized. Use copper conductors only.
Failure to follow these instructions will result in death or serious
injury.
FSequence IPM Install Guide.book Page iv Thursday, October 6, 2011 3:21 PM
Summary of Contents for Freedom Sequence
Page 2: ...FSequence IPM Install Guide book Page ii Thursday October 6 2011 3 21 PM...
Page 10: ...FSequence IPM Install Guide book Page ii Thursday October 6 2011 3 21 PM...
Page 30: ...FSequence IPM Install Guide book Page 20 Thursday October 6 2011 3 21 PM...
Page 31: ...FSequence IPM Install Guide book Page i Thursday October 6 2011 3 21 PM...