Basic Installation Procedures
38
Freedom X Owner's Guide
Connecting to ACC Signal
To enable ignition control:
1. Ensure that AC and DC power are both OFF.
2. Ensure the vehicle’s ignition is turned to OFF position. It is
highly recommended to remove battery power by
disconnecting the vehicle's battery cables. Refer to the
vehicle’s user manual for proper instructions on how to
disconnect the battery cables.
3. Locate the vehicle's ignition control wire from the vehicle’s
ignition circuit. This wire must be fused appropriately at no
more than 5 amps. Refer to the vehicle’s user manual for
guidance.
4. Locate the ACC input (ignition signal input) terminal on the
right side of the connector. The left terminal is not used at
this time. See
Figure 13 Ignition signal (ACC) input terminal
5. Using a 3mm slot long neck screwdriver, push into the
rectangular slot to release the spring clamp.
6. Insert the ignition control wire into the round ACC input
terminal slot.
7. Pull the screwdriver out to engage the spring clamp and
secure the wire to the terminal.
Description of Ignition Control Features
For information about the features and instructions on changing
the ignition control features, see
.
Ignition Auto-
on (
ATO
)
This setting allows the inverter to operate
(Battery mode) automatically when an
ignition control wire is connected to the
ACC input and a valid ignition signal is
constantly detected. The inverter works in
tandem with the vehicle’s ignition circuit.
Ignition Lock-
out (
LOt
)
This setting allows the inverter to
operate (Battery mode) when an ignition
control wire is connected to the ACC
input terminal and a valid ignition signal
is constantly detected.
When enabled, you have to manually
press the Power button on the display
panel to operate the inverter.
Off (
OFF
)
To completely disable the ignition control
features do the following:
Set Ignition Control to Off (
OFF
) using the
Select buttons on the Display panel.
Table 10 Ignition Control Features
