Configuration
Sorensen SLM-4 Chassis
SLM
Figure 2–3 SLM-4 chassis Rear Panel
2.2.2 RS-232C
Connection
The RS-232C connector (female) on the rear panel connects the SLM-4 chassis to the
computer's RS-232C port.
2.2.3 Analog
Programming Input
The D-sub 9-pin connector on the rear panel connects the SLM-4 chassis to the SLM-Series
single input, the DC load module analog programming input, or to the external sync input of
SLM-Series AC load module. The pin connections are defined as shown in Figure 2–4.
CH1+
CH1-
CH2+
CH2-
CH4+
CH4-
CH3+
CH3-
1
5
Figure 2–4 Diagram of Analog Programming Input
2.3 MAINTENANCE
2.3.1 Cleaning
WARNING
:
To avoid electrical shock or damage to the meter, do not get water inside the
case.
Periodically wipe the case with a damp cloth and detergent; do not use abrasives or solvents.
2-4
M540069-01 Rev B
Summary of Contents for SLM-4
