20
2.0 Installation
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0049-01-01 Rev A 10/2002
AC Wiring (continued)
Hardwiring the AC Input and Output (if required)
Some models may require you to hardwire the AC input
and output. If your unit requires hardwiring the AC input
and output, follow the directions on pages 21 through 22.
Use a minimum 14 AWG, solid wire for all input and
output wiring. Check with your local electrical codes for
absolute compliance on this wire size.
Knockout Preparation
Remove the knockouts from the end panel as shown
below for AC IN and AC out wiring.
Figure 2-14
Knockout locations for AC IN and AC OUT Wiring
Two (2)
Knockouts for
½” conduit or
strain relief
½” conduit or
strain relief
Output receptacles may
or may not be present
on these models.
