Installation
Load Connection
34
Operating Manual for XKW 1kW Series Power Supply
Assembly Instructions
1. Snap off the rectangular bushing attached to each piece of the strain relief. See
Figure 2.3
.
Figure 2.3
Strain Relief
(One piece, inside view)
2. Install bushings on strain relief pieces, as required. Cable diameter must be
between 0.120" and 0.650"
.
3. Insert strain relief tab A into DC output connector slot A. Insert strain relief tab
B into DC output connector slot B. See
Figure 2.4
.
4. Install screws in holes provided on outside of strain relief pieces. Thread through
to screw standoff inside opposite piece. Tighten to clamp outer jacket of output
cord securely, ensuring that the side of the strain relief slips into the
corresponding rabbet on the opposite piece.
Figure 2.4
Strain Relief Assembly
