6
Recharging xPower1500
1. The battery’s charge level may be seen by pressing the Battery
Status switch on the AC Power Panel.
2. To recharge, plug the AC Charger into a standard 115-volt AC
outlet and the DC plug into the DC Power Socket (located on the
DC Power Panel). The Recharge Indicator on the AC Charger will
change from amber to green when charging is complete (up to 15
hours). It is safe (and recommended) to leave the AC Charger
connected indefinitely.
IMPORTANT: Review the safety information in the AC Charger
Owner’s Guide (also enclosed) before recharging xPower1500.
3. Charging may also be done from an automobile lighter socket.
See Section 7 for details.
Using xPower1500 to Jump-Start Your Vehicle
Due to potential dangers, see Section 6 for a detailed explanation.
23
9 Battery Replacement
The batteries used in xPower1500 are a high quality, state-of-the-art design
that will serve as a reliable power source for years when properly maintained.
To maximize battery life it is important to recharge xPower1500’s battery pack
after each use, recharge fully every three months if placed in storage, and
store in a location that maintains a temperature range of 32º to 104ºF (0º to
40ºC). Also, discharging the battery pack below 10.0 volts will shorten its
life.
IMPORTANT:
The battery pack is covered under warranty only when it is
properly maintained.
Replacing xPower1500’s Internal Battery Pack
Before attempting to replace the battery pack, contact Xantrex
Customer Service for specific instructions. See contact information
in the front of this Owner’s Guide. Provide Customer Service with the
serial number of your unit (located under the lid of the Accessory
Storage Compartment). If you do not know how to safely remove
and install higher amperage batteries, have this task preformed by a
qualified service technician.
WARNING:
To avoid potentially serious injury, follow these
precautions when working with batteries:
1. Someone should be within range of your voice or close enough
to come to your aid when you work near a lead-acid battery.
2. Have plenty of fresh water and soap nearby in case battery
acid contacts skin, clothing, or eyes.
3. Wear complete eye protection and clothing protection. Avoid
touching your eyes while working near batteries.
4. If battery acid contacts skin or clothing, wash immediately
with soap and water. If acid enters your eye. immediately
flood it with running cold water for at least twenty minutes
and get medical attention.
5. Keep a supply of baking soda on hand in the area of the
batteries. Baking soda neutralizes lead-acid battery electrolyte.
6. NEVER smoke or allow a spark or flame in vicinity of the engine
or batteries.
7. Be extra cautious to reduce the risk of dropping a metal tool
on the battery. It might spark or short-circuit the battery or
other electrical parts that may cause an explosion.
ARTWORK FILM No. 445-0127-98-01 REV. 1 MAY 10/2001
