SCPI Command Reference
A-2
M370046-01
SCPI Conformance Information
Codes and Standards
This power supply conforms to the following international standards:
•
IEEE Std. 488.2-1992, “IEEE Standard Codes, Formats, Protocols,
and Common Commands For Use With IEEE Std. 488.1-1987”
•
IEEE Std. 488.1-1987 “IEEE Standard Digital Interface for
Programmable Instrumentation”
•
TIA/EIA-232F
•
Standard Commands for Programmable Instruments (SCPI) Version
1999.0
IEEE 488.2 Requirements
GPIB control implements all IEEE 488.2 requirements.
SCPI Requirements
The power supply conforms to the following SCPI requirements:
•
SCPI mandated commands
•
Questionable Status Register (QSR), Condition, Event, Enable
•
Operation Status Register (OSR), Condition, Event, Enable
•
Status Byte Register (SBR)
•
Standard Event Status Register (SESR)
IEEE 488.2/SCPI Syntax and Style
Parameters: Units of Measure and Multipliers
Refer to IEEE 488.2, section 7.7.3 for the definition of units of measure.
The default units of measure include:
•
V (Volt – voltage)
•
A (Ampere – current)
•
W (Watt – power)
•
S (seconds – time)
These units are only supported as defaults. To place the unit in the
command will cause an error to be pushed into the error queue.
All manuals and user guides at all-guides.com
Summary of Contents for XTR 100-8.5
