Using the XW System Control Panel
975-0400-01-01
B–5
Changing Settings Using the System Control Panel
If you need to change a XW SCC setting, use the buttons on the System Control
Panel to perform three basic steps:
1. View the Select Device menu.
2. Select the XW SCC from the Select Device menu.
3. Select and adjust a changeable setting on the XW SCC Setup menu. See
page B–8.
Each of these three steps is described in detail in the following sections.
Viewing the Select Device Menu
The Select Device menu is where you select a Xanbus-enabled device to monitor
or configure. The number of items on the Select Device menu depends on how
many devices are installed in your Xanbus system.
To view the Select Device menu:
u
On the System Home screen, press Enter.
Viewing the XW SCC
Setup Menu
On the Select Device menu, select the XW SCC to view and change its settings.
To select the XW SCC from the Select Device menu:
1. On the Select Device menu, use the down arrow button to highlight XW-
MPPT60-150.
2. Press Enter.
The Setup menu appears.
Note:
You can also view the XW SCC Setup menu by pressing Enter from the XW
SCC Home screen. See “XW SCC Home Screen” on page B–10.
Important:
You can always identify the System Home screen by the menu arrow in the
bottom left corner of the screen. The menu arrow indicates the Enter button on the System
Control Panel, which you press to view the Select Device menu.
Figure B-3
Selecting the XW SCC
Select Device
MPPT60 01
Summary of Contents for XW-MPPT60-150
