X3102r user manual V. 2.0
30 / 33
The following (example) will be displayed for checking your
setting
Setup Configuration
FUNCTION: PPPOE
Ethernet IP: 192.168.1.1
Subnet Mask: 255.255.255.0
# VPI VCI AUTH USERID
1: 8 40 PAP xavi
Preserve the configuration (y/n): (
“y”
to use the setting
or
“n”
to leave without change. Start again to set
parameters)
Configuration will have no effect until after save and
restart.
All the parameters will not be effective under the setting
being saved and restart again. Above message is to remind
operator
5.3 NAT function
NAT function will be enabled automatically when PPPoE
routing set. This function will enable PC users in your LAN
environment to access outside with only one IP address (IP
sharing) and one access account.
If you have any application or server in your LAN
environment, which is available for outside uses, please
configure the PAT (port address translation) table to enable
this kind of service by following the example below,
otherwise continue to section
5.4
Use the following example to set NAT function for PPPoE
routing.
>pat (with
“enter”
key to go to pat director)
>pat>addpatin pppoa 434/udp 210.18.35.10
(Addpatin – command for add incoming pat table)
(pppoe – set PAT table for PPPoE routing. PAT table is
service related)
