X3102r user manual V. 2.0
32 / 33
commands)
>lan>dhcpserver 192.168.1.1 192.168.1.10
192.168.1.20 192.168.1.30
(There are two range of IP segment allowed for DHCP
server. Both segment must be in the same subnet with LAN
IP address. Refer to the LAN IP address set for the routing
function (RFC1483 or IPoA or PPPoA or PPPoE) previously.
For example 192.168.1.1 – start IP address of segment 1;
192.168.1.10 – end IP address of segment 1;
192.168.1.20 – start IP address of segment 2;
192.168.1.30 – end IP address of segment 2)
Continue setting up DNS server address for assigning to
PC.
>lan>dhcpserver dns 210.65.18.1 210.65.18.20
(There are two DNS server address could be assigned – for
example 210.65.18.1 and 210.65.18.20. Your service
provider (ISP) should give you those address when you
subscribed service. Use them as right IP address)
6.2 Save the configuration to router permanently and make
settings effective by following steps below
>lan> home (with
“enter”
key to execute)
You can use “show” command to check your setting again.
>>save (with
“enter”
key to execute)
Wait until the following message displayed on your screen
completely. Don’t power off the modem during this stage.
Saving configuration...
Configuration saved.
Updating flash filing system ...
SDRAM size = 0x800000
Booting...
System starts...
