X3102r user manual V. 2.0
33 / 33
7 DNS (Domain name server) Relay Setting
The DNS relay function allows DNS request to be
terminated in the router.
To make this function effective, the DNS address on PCs
should be set to the LAN IP address of router. Refer to the LAN
IP address set for the routing function (RFC1483 or IPoA or
PPPoA or PPPoE) previously.
7.1 Following below example to set DNS relay configuration.
>>dnsrelay ( with
“enter”
key to execute)
>dnsrelay>setdnsip 192.168.8.1
(Your service provide (ISP) should give you DNS address
when you subscribed service. Use it as right IP addresses.
192.168.8.1 is just example)
7.2 Save the configuration to router permanently and make
settings effective by following steps below
>dnsrelay>home (with
“enter”
key to execute)
You can use “show” command to check your setting again.
>>save (with
“enter”
key to execute)
Wait until the following message displayed on your screen
completely. Don’t power off the modem during this stage.
Saving configuration...
Configuration saved.
Updating flash filing system ...
SDRAM size = 0x800000
Booting...
System starts...
