X5368r-P3
User’s Manual Version 1.0
7
VI. Hardware Installation
Follow the steps below to set up your device:
Step 1:
Connect one end of the ADSL cable to the WAN port of
X5368r-P3
and the other end to the ADSL wall outlet.
Step 2:
Use a RJ-45 cable to connect one end to an Ethernet port
of
X5368r-P3
and the other end to the LAN or a PC with an
Ethernet adapter installed.
Step 3:
Plug in telecom line for out line calls.
Step 4:
Plug in IP Phone for extension calls.
Step 5:
Plug in the AC adapter to the AC power socket, and then
connect the DC jack to the PWR inlet of
X5368r-P3
Push
the On/Off button to turn it on.
Note:
Be sure to use a RJ-45 crossover cable while connecting to a hub.
ADSL Outlet
1
2
Management
Terminal/
4 PC
3
Power Supply
Telecom
Line
X5368r-P3
User’s Manual Version 1.0
8
VII. Management
There are several ways that you can make the configuration:
Local Ethernet Port (telnet)
– connect the Ethernet port to
your local area network or directly to a PC, “Telnet”
X5368r-P3
from any workstation in the LAN. The default
local Ethernet IP address is “192.168.1.1”. See Chapter 2,
Command Line Interface, for more details.
Local Ethernet Port (Web browser)
– connect the Ethernet
port to your local area network or directly to a PC. Launch
your Web browser and enter default local Ethernet IP
address “192.168.1.1” into the address bar.
ADSL Port from Remote Site
– while the ADSL connection
is in service, you may remotely “Telnet”
X5368r-P3
from a
workstation connected to the CO equipment.
Note
: As operating an ADSL device requires technical know-how and
experience, it is recommended that only qualified technical staff manage
X5368r-P3
Therefore, a password authentication is required when you
enter the command line and Web interface. See the
Default Values
section to obtain the password.
