X7968r
User’s Guide
Quality of Service, global settings:
Enter the profile name and rule name for this classifier (rule)
Generic Classification: These values try to match all bytes in the packet starting
at a valid offset from the Ethernet header. The valid values for Offset are 0 -
1500. The Mask and Values must be hexadecimal values ranging from
0x000000000000 to 0xffffffffffff. All the incoming packets will be matched against
the configured values of offset, mask and values. If the incoming packet values
matches than the configured action will perform.
Prioritize packets in Layer 2: All the incoming packets will be matched against
the configured values of VLAN-ID and VLAN-ID min- max values. If any of the
rule matches than the corresponding action will be performed.
•
802.1p priority bits
•
VLAN ID value
Prioritize packets in Layer 3: All the incoming packets will be matched against
the configured values of the layer 3 fields (source/destination IP address, mask,
DSCP values etc.). If any of the rule matches than the corresponding action will
be performed.
•
Packet type which is prioritized and data length
•
Source IP address and subnet
•
Source port range from start to end
•
Destination IP address and subnet
•
Destination port range from start to end
•
Enter the physical port
•
Check one of IP TOS (Type of Service) and DSCP
Assign the traffic priority, Mask VLAN Priority, Drop Priority, Mark IP TOS or
DSCP, and set Meter-ID. The corresponding IP TOS in IP header of packet will
be overwritten by this new value.
Click
Apply
to add this QoS rule.
QoS Setting
Figure 60: QoS - Attaching Classifier Profile
Select the transport from
Select the Transport
drop down list.
Select the classifier profile to be attached to the transport from
Select the
Classifier Profile
drop down list.
Click
Apply
.
52
