5
ASSEMBLY
ALWAYS
make sure the unit is
unplugged before
beginning
assembly
!
NEVER
move or
clean the heater, or change the bulb(s), while it is
plugged in
.
1)
Carefully turn the
STOVE (A)
upside down and lay it on a clean soft surface.
2)
Align the holes in the leg
(B)
with the holes in the corner of the stove frame as shown.
3)
Thread three
SCREWS (C)
through the holes in the leg and into the stove frame. Partially
tighten the screws with a Phillips screwdriver.
4)
Repeat Steps 2 and 3 for the other three legs.
5)
Check the alignment and tighten all 12 screws securely with the screwdriver.
DO NOT
over-tighten the screws.
ALWAYS
attach the feet before using!
NEVER
plug in or operate this unit if the feet are
not securely attached!
