XceedID : Document No: 0469-01; Issue No. 1; 4/12/2007
INSTALLATION SHEET
XF2200/XF2210
PARTS
LIST:
•
1 - Installation Sheet
•
1 - Mounting Plate
•
1 - Potted Reader Assembly
•
1 - Cover
•
2 - Mounting Screws
•
1 – Cover Assembly Screw
Removal:
1. Remove unit from box.
Mounting the Reader:
1. Determine an appropriate mounting position on a single gang box or wall. Be sure to
account for any applicable ADA height requirements.
2. For a single gang box mount, attach the back-plate to the holes in the single gang box
using the screws provided.
3. For a wall mount, drill two mounting holes between 2.5” (63.5 mm) and 3.5” (88.9 mm)
apart on the mounting surface. Drill holes to make a hole on the wall about the same
size as the rectangular opening in the mounting plate ( 1.4” x .53” or 35.6 mm x 13.5
mm) for the connector and cable wire connection to the host.
4. Connect the mounting plate to the wall using the screws provided.
5. Wire the unit according to the color code chart below ensuring that all connections are
made through the rectangular hole in the mounting plate.
6. Hook the top of the potted case assembly to the top of the mounting plate.
7. Swivel the unit down into place and snap the cover over the potted reader assembly.
8. Install the screw from the bottom to fix the cover to the potted case to the mounting
plate.
Cable Connections:
1. XceedID XF2200/XF2210 readers are supplied with a 12 conductor cable that contains a
connector on one end and tinned wires on the other end. Connect these wires to the
host/panel being careful to match the color of each wire with the chart shown below.
Green =
Data 0
White =
Data 1
Orange = Green LED
Brown =
Red LED
Red =
Power +DC (5-16 VDC)
Black =
Ground
Tan = Tamper Output
Pink =
Card Present
Yellow =
Beeper
Gray =
Not Used
Purple =
Not Used
Blue =
Not Used
