5
Installation Instructions (Panels ONLY)
1. Locate Top Rail, Middle and Bottom Rail
2. Place Middle & Bottom Rail on the Floor, facing Up
3. Insert individual Pickets into the Rail Holes
4. Make sure holes are facing to the Right and Left
5. Place Top Rail on opposite side of Pickets
6. Make sure Grommets face the Pickets
Installation Instructions (At Job Site)
1. Draw and measure layout of where the fence will be installed
2. Mark locations and distance between posts to 76” apart
3. Set posts (dig hole 18-24” deep or use Flange for concrete)
4. Use and attach brackets to posts
5. Install Rails to brackets (rails will follow your terrain)
6. Insert pickets through the bottom rail, then pull up to attach the top rail.
7. You are done!
Attach
top
and
bottom rails to a post
Drill to concrete to
secure post
Use Bolts to tighten
Posts into the ground
Secure Brackets on
posts for rails
Insert pickets through
the bottom rail first
Pull up pickets to clip
on top rail
You are done
Insert pickets through
the bottom rail first
Pull up pickets to clip
on top rail
You are done
