17
©
2015 Hubsan
哈博森科技 版权所有
The transmitter will automatically find the best frequency to ensure a live video with good
quality of transmission. Please re-select the frequency from 5730MHZ to 5845MHZ to get a
better video transmission when necessary.
Pull the throttle stick to the lowest position and press the Elevator stick for 1.5 second to enter
into the MAIN MENU interface. Push the Elevator stick up/down to select “5.8G Frequency”,
push the stick to the right to enter into the “ 5.8G frequency” interface, select a matched
frequency.
5.8G FREQUENCY
0:08:49
Exit
5730MHZ
M2
Mode 2:
Push both sticks to the upper left corner and power on the transmitter simultaneously, the
LCD will display “Calibrate Stick Mode 2”, rotate both sticks in circles for three times, release both
sticks, then press any trim for 1.5 seconds until one “beep” heard which indicates a successful
calibration.
Mode 1:
Push the left stick to the upper left corner and the right stick to the upper right corner and
power on the transmitter simultaneously, the LCD will display “Calibrate Stick Mode 1”, rotate both
sticks in circles for three times, release both sticks, then press any trim for 1.5 seconds until one
“beep” heard which indicates a successful calibration.
The transmitter mode can be shifted according to the above operation.
!
0:08:49
MAIN MENU
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
Fly When no GPS
Show Version
Exit
M2
10. TRANSMITTER CALIBRATION
11. FREQUENCY SELECTABLE 5.8GHZ
Summary of Contents for HUBSAN X4 FPV BRUSHLESS
Page 19: ...19 X4 FPV Brushless DE...
Page 42: ...22 2015 Hubsan...
